Pre-vizsla Dark Saber [Build in progress]

JeanAlbert

New Hunter
Hi everyone ! i hope i post it in the right place !
i'm in the progress of designing a toy/replica of the Dark saber of Pre-viszla in star-wars the clone wars series.
the aim is to get a fairly good replica of the design but with the ability to unfold a blade by a simple movement. the whole thing will be 3D printed and will be available for free in thingiverse (for whose who will want such a thing ^^)

here my progress so far :
Capture.PNGP1010966.jpgP1010967.jpg

i'm just a beginner in design, and 123D design too... and ffor the moment i'm quite struggling to get the results i want.
i think i've made a mistake on the design of the blade, it's too complicated. i rather redo the whole blade with a shape more like a triangle, kind of a scandi-grind blade if you see what i mean.
the inspiration for this project came from this design : Customizable crossguard lightsaber, from The Force Awakens by LeFabShop - Thingiverse

i hope i'll have the abilities to finish it ^^
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top