Hutt Family Workshop helmets history ( from paper to fiberglass and painted)

6IcguHVtFHY.jpgcEeiHtVkjXQ.jpg

IqaU-sfERl0.jpgGgpe9Fdh-98.jpgz9fvzjDRNOI.jpg

soon I will make silicone molds, just need a little to finish the helmet
wQ9bZaz2jxA.jpg

6IcguHVtFHY.jpg


cEeiHtVkjXQ.jpg


IqaU-sfERl0.jpg


Ggpe9Fdh-98.jpg


z9fvzjDRNOI.jpg


wQ9bZaz2jxA.jpg
 
Last edited by a moderator:
Small update.
I finished the helmet, a little spoiled silicone molds, so didn't do the photo, there is nothing new or unusual.

Here is the result of simple colored paint mtn 94 and mtn hardcore, made weathering simple acrylic paint and a sponge.



_0003.jpg_0007.jpg_0006.jpg_0008.jpg

B6dbDCvAfzQ.jpgoj1IEWbD6Rw.jpgaVFIWGnUa6c.jpghD8Jzky4bJo.jpg

ps
What model of airbrush is best to use for large surfaces?
Where to read and learn to make a helmet out of fiberglass?

^ ^

_0003.jpg


_0006.jpg


_0007.jpg


_0008.jpg


B6dbDCvAfzQ.jpg


oj1IEWbD6Rw.jpg


aVFIWGnUa6c.jpg


hD8Jzky4bJo.jpg
 
Last edited by a moderator:
Really nice! On par or better than a lot of scratch built helmets I've seen. I think you can sell your kits no problem.
 
Last edited by a moderator:
Very soon I will have a primitive rotocast machine.


And I think about small run on the helmet, what do you say? )

JH-kuT2O8yo.jpg

JH-kuT2O8yo.jpg
 
Last edited by a moderator:
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top