Boba Fett Rifle

[Radioman1017]

Le1120, it's not a new trigger. It's a piece I made that connects the pieces called "handle" and "trigger bit". There's a slot on the "trigger bit" and a flat surface on the "handle". That's a very key balance point on the gun and it's very difficult to clamp while the glue dries. I created and glued a tab on the handle side so that when you go to attach, there's much more surface area for your epoxy. Happy to share the piece. Just PM me.



Here's how the two pieces look in the file. Below is the handle (with the stock holder glued to it but that's irrelevant for this discussion) looks with the tab glued to it.



Happy to share the piece. Just PM me.

Mark

 

[hamsandwich72]

Radioman, it looks awesome! Curious; did you sand or acetone bathe the pieces to smooth them out?

Thanks.

 

[fomare]

Nice workkkk!

 

[RexFett]

Looking friggin' awesome...god job brotha

 

[Radioman1017]

Radioman, it looks awesome! Curious; did you sand or acetone bathe the pieces to smooth them out?

Thanks.

No, I prefer to print in PLA which doesn't respond to acetone baths. Now that I have one done, I have some planned upgrades for the next. For that one, I'll probably do ABS or HIPS.