Gifted Boba Maker Helmet Repair/Paint-Up

Since I finished my EE-3 last week, I can now turn my attention back to the helmet.

First I enlarged the hole for the borden because it was much too small for the aluminum one I have. The kit came with a small resin one.

46C14261-3ECC-47EF-BFD3-B24A5ACF6BC7.jpeg

C8E52B33-2EC6-4053-B089-E2F7FFBF0AD1.jpeg


Masked up and green shot on.
A4F03CCC-E1FC-4E7B-B928-543CFC75BEB4.jpeg


Silver damage completed.
A5C0C1A5-C13C-4AF6-8387-285B9120A7FC.jpeg
 
Made up a stencil for the killstripes so I could lightly trace the shape in order to line up the surrounding damage properly. This is the first time I have used this method and had been a difficult step for me on my previous helmet getting everything lined up correctly. In theory it should help.

F30D2688-6746-48AF-B0E9-8CBED15C431E.jpeg

CFA11239-F54C-408A-95F1-ADA7F3AEB034.jpeg
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top