Chest electronics attachment?

[Alzreal]

So as the title states, how did everyone go about attaching their electronics inside the chest plate? I have a set of FP armor and a fettronics display.
Plus where do you stash the battery box?
I apologize if this topic has been covered already, I couldn't seem to find many posts on this.

 

[01Hawk]

I just used duct tape to hold the lights in. I poked a hole in my vest and run the wire behind it and out to the left pouch on my belt where I keep the battery box.

 

[tterrell]

Aye, I used duct tape + hot glue.

 

[Gregory]

I used hot glue at the corners, and made a pocket for the battery pack on the back half of my flak vest, inside of course.

 

[C1RCA]

yeah hot glue for me as well

C

 

[toolguy301]

I used velcro, which has worked great & has been very secure.

 

[Malkavian]

I used hot glue at the corners, and made a pocket for the battery pack on the back half of my flak vest, inside of course.

How did you make a pocket to the vest? I was thinking the same but was afraid the stitching would show on the outside.

 

[Gregory]

I used white thread, it's pretty hard to see. It's on the back half down low so I think the back armor covers it anyway.

Sent from my XT1049

 

[Fett 4 Real]

Hot glue or duct tape...and the battery is in the jetpack... Booboo Fett inspired me to connect mine like it should be as seen on the movie suit using an XLR plug

http://www.thedentedhelmet.com/f20/bbfs-rotj-fett-no-more-se-39246-post544784/#post544784

http://www.thedentedhelmet.com/f20/bbfs-rotj-fett-no-more-se-39246/

 

[Alzreal]

Awesome info!

 

[hooligan68]

Duck tape & velcro straps

 

[al13ns]

will the sweat cause short circuit to the board ?