So this just happened...

Ghostbones

New Hunter
HELMET BROKEN.JPEGI was working on putting the lens on and this happened. After shouting and drinking a few beers I have calmed down. What can I do??
imagejpeg
 
Last edited by a moderator:
Does the piece fit neatly? Some glue and then filler on the inside should fix it up. Not sure how it'll affect mounting your visor though.
 
Damn....
best way to fix it is to glue or epoxy it. Then grind into the crack line a bit to make s small trough, and use a filler to fair it in. That sucks man....
 
two part epoxy glue. Time consuming but absolutely permanent.

Feel for you brother but nothing is undoable. You'll do it!

Good luck.

I use UHU 2 part epoxy but there are many out there.
 
It can be salvaged. Try two part epoxy to join the pieces and reniforce the inside with a few layers of fiberglass resin and fiberglass mat. Then try glazing putty to smooth the seam on the exterior.

Give it a few days to think about it, you've gone to far to quit.
 
Dont sell it man, its an easy fix. take up Mugatu's offer and have him fix it for you. Ive seen much worse damage get fixed up!
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top