Plug block question

[viewoptic]

I’m wondering what the best way is to install the mono plugs into the plug block? The mono plugs cannot be installed from outside due to size of holes. I’m assuming the holes have to be drilled larger and then just glue the plugs in, but just wanted to check with everyone.
Thanks

 

[BudaFett]

I printed a hallow block and used real plugs still connected to a wire and connected that to the wire through the hose to the connecting XRL cables to the jetpack connector.





Now, if you just wanted to install the plugs, I would cut off what I don't need and glue those into place.

 

[viewoptic]

I printed a hallow block and used real plugs still connected to a wire and connected that to the wire through the hose to the connecting XRL cables to the jetpack connector.

View attachment 241408View attachment 241409



Now, if you just wanted to install the plugs, I would cut off what I don't need and glue those into place.

Thanks, I plan on soldering the XLR wires the same as you have done.

 

[BudaFett]

That's the way to go!