Plug block question

viewoptic

Hunter
TDH PREMIUM MEMBER
I’m wondering what the best way is to install the mono plugs into the plug block? The mono plugs cannot be installed from outside due to size of holes. I’m assuming the holes have to be drilled larger and then just glue the plugs in, but just wanted to check with everyone.
Thanks

IMG_5402.jpeg
 
I printed a hallow block and used real plugs still connected to a wire and connected that to the wire through the hose to the connecting XRL cables to the jetpack connector.

IMG_4594.jpegIMG_4593.jpeg



Now, if you just wanted to install the plugs, I would cut off what I don't need and glue those into place.
 
I printed a hallow block and used real plugs still connected to a wire and connected that to the wire through the hose to the connecting XRL cables to the jetpack connector.

View attachment 241408View attachment 241409



Now, if you just wanted to install the plugs, I would cut off what I don't need and glue those into place.

Thanks, I plan on soldering the XLR wires the same as you have done.
 
This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top