Bended resin

trmee001

Hunter
Hey hunters!
Hope u all doing fine!
I have a interesting problem.
The resin ear of my kit is quite crooked.
I tried heating it in warm water, but it don't work.
Maybe heat it in the oven is better. On a plane surface so it finds its level on it self?

Any help would be awesome!
20210928_174335.jpg
 
Hot box it, put it in a cardboard box with hole in the top (like a lonely island song) and a hair dryer business end in said hole. Turn it on high and leave it for about 10 minutes. Gently trigger clamp it to a flat surface and let it cool over night.
 
Hot box it, put it in a cardboard box with hole in the top (like a lonely island song) and a hair dryer business end in said hole. Turn it on high and leave it for about 10 minutes. Gently trigger clamp it to a flat surface and let it cool over night.
This has got to be one of the best tips I've ever read lolololol
 
Great tips my friends ! I decided to give the hotbox a try. Took my girlfriends hairdryer and cook the ear for 10 minutes.
First it bends even more. Then I clamped it. The trick is to not crush the edge Detail.
Now waiting till tomorrow to cool down :)
20210930_150956.jpg
20210930_151220.jpg
20210930_152415.jpg
20210930_153054.jpg
 
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top