Pistols 3D Printed Westars

Nyx Mandalore

Jr Hunter
So I've been away for a while and I'll be honest, my progress totally stalled when I realized how hard it would be to get my hands on a set of Westar pistols. It seemed kind of like there wasn't much point if you couldn't obtain such a critical component. But today, as a lark, I started looking around again. I stumbled across this:

ETSY 3D Printed Blasters

Does anyone have any experience with these? If so, how'd they fare? And what did they look like painted if you have pictures?

Apologies if this is a re-post - I did a quick search but didn't turn up anything.
 
Everything on that 3D printed Westar-34 looks good. except the flash suppresser doesn't look like it has the right shape. But I guess if you keep it holstered who would know. Personally just knowing that it's not right would drive me nuts though.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top