Superjedi's MCR-ESB for D. Smith

Thanks!

I worked on the center section of the red band. All that nice clean red is disappearing!

20220412_180519.jpg
 
Taking a very brief break from painting to play with some electronics!
This helmet build includes an awesome RF light kit by JC27. It's designed to fit the Terminalfettler RF topper, and has 2 blinking red LEDs and 3 tiny white LEDs. All you have to do is hook up the wires using solderless connectors, and put in a 9-volt battery.
Light check... complete!

IMG_20220420_081400_451.jpg
 
Thanks!

The final stages went quick! So here is number 61 all finished!
As always, I had a lot of fun working on this one. To recap, this was a Machinecraft Replicas MCR-ESB kit that the owner cleaned up and did the prep work on. It came with machined metal ears and Borden piece, a Terminalfettler RF topper, and a JC27 light kit.
Very cool assortment of parts!
Thanks for following along with the build, and I'll be back soon with another helmet.

20220424_183337.jpg 20220424_182641.jpg 20220424_182741.jpg

20220424_183144.jpg 20220424_183049.jpg 20220424_182943.jpg

20220424_183237.jpg 20220424_182854.jpg 20220424_183732.jpg
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top