Superjedi's FPH2 ESB for JCFett

Killstripes are on. :) (y)
Here are the prep steps.

First, everything is taped off. I use Winsor and Newton masking fluid to make the small chips.

20190527_064932.jpg 20190527_065127.jpg

I use plastic wrap to protect the helmet.

20190527_065949.jpg

Then I airbrush the yellow, and mist the back stripes with a little bit of orange.

20190527_081130.jpg

Looks like a big mess! But once everything is unmasked, we wind up with our familiar stripes.

20190527_081111.jpg 20190527_081046.jpg 20190527_081029.jpg

Now I can work on the damage between the stripes.
 
I finished the remaining detail on the left side of the dome.

20190527_140810.jpg 20190527_140743.jpg 20190527_140719.jpg

I also laid down the dark color on the outer cheeks.

20190527_154853.jpg

I'll start detailing the cheeks tomorrow. (y)
 
Thanks. The green is so tricky. It always looks a little lighter in pics than it does by eye.
The final wash and weathering will change the tone slightly, too.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top