Need Some Help with Helmet Paint

mrwaffles2

New Hunter
I'm a bit new to this, but I've recently started work on a Boba Fett Helmet build and started looking at the paint stencils. I've found they don't quite line up with my pepakura files. Is this common or something I should be worried about? All help is appreciated
 

Lynn TXP 0369

Well-Known Hunter
You will probably have to try different print sizings, up or down in size, until you get it to your helmets size. It will be trial and error to get the right size print for the stencile.
 

ToEleven

Active Hunter
An image editor (like photoshop) that will let you load in the pdfs and stretch or skew to fit is what I've had to use. It's a lot of trial and error...printing, adjusting and reprinting.
 

mrwaffles2

New Hunter
An image editor (like photoshop) that will let you load in the pdfs and stretch or skew to fit is what I've had to use. It's a lot of trial and error...printing, adjusting and reprinting.
Good to know its not just my pepakura files. Would hate to put in all the work just to realize the base model was messed up.
 
Top