Hey Guys,
I'm posting the thruster assembly. I've had some problems keeping it organized through email. This assembly has worked very well for me in the past.
Photo 1. The finished thruster assembly.
Photo 2. Supplies: Small length of 3/4" pvc pipe. Four 3/4" pvc elbows. Adhesive of your choice (Not shown).
Photo 3. Measurements: Cut one section of 3/4" pvc pipe to 9 3/4" length. Cut two sections of 3/4" pvc pipe to 2" lengths.
Photo 4. Secure each 2" section to your elbows with adhesive.
Photo 5. Make final assembly inside fuselage with adhesive.
Photo 6. Attach thrusters to pvc assembly with adhesive (Use your template which came with your kit to cut hole inserts).
Photo 7. Check for allignment and allow adhesive to dry.