I plan to have this kit around for a while..no worries !
Lanyard mold is completed. I'll be finishing up purchased orders over the next few days. I may be offering the lanyard as a single prop. I know there were many of you interested in the lanyard alone so keep posted.
I would be interested in this, however funding at present time is rather stretched... how long will these be going for, and what lanyard would you reccommend for a 5'6"ish stocky guy? Assuming that you are the person doing the shorter one as well...
I'm posting the thruster assembly. I've had some problems keeping it organized through email. This assembly has worked very well for me in the past.
Photo 1. The finished thruster assembly.
Photo 2. Supplies: Small length of 3/4" pvc pipe. Four 3/4" pvc elbows. Adhesive of your choice (Not shown).
Photo 3. Measurements: Cut one section of 3/4" pvc pipe to 9 3/4" length. Cut two sections of 3/4" pvc pipe to 2" lengths.
Photo 4. Secure each 2" section to your elbows with adhesive.
Photo 5. Make final assembly inside fuselage with adhesive.
Photo 6. Attach thrusters to pvc assembly with adhesive (Use your template which came with your kit to cut hole inserts).
Photo 7. Check for allignment and allow adhesive to dry.
Note: PVC pipe is measured by inside dimensions. Use 3/4" (inside) PVC and appropriate elbows
do you sell all your stuff as a kit or is it possible to get all this fully built and painted ? I'm new on the DEN and have to look what parts for my Boba are interessting for me so i just wanna check this out. Sadly i dont have the skills to built or paint stuff myself.