Help: ISO Servo stalk extension for the Hi Tec HS77B

T

T90

Jr Hunter
Hey guys, as many of us have done in the past I am upgrading my Fett. I have gone with a Premium Animefan cold cast bucket and I am very pleased with my decision.

Since I have the new helmet I will be retiring my original lid to a display shelf as a personal accomplishment and display piece, in doing so though I am pulling out the servo and RF board that I had installed.

Now when I installed the servo in my pep helmet I was able to install it in such a way that the servo gear was almost flush with the outside of the helmet so attaching the RF stalk was relatively easy. The method I used previously will not work for my new helmet, and I need to find an aluminum shaft extension for the servo. I am using the HI Tec HS77B low profile servo and I can't seem to find the extension stalk for the servo anywhere. Could someone point me in the right direction.

Thanks
 
Servo city discontinued the aluminum shaft extension a while ago. That's why I started supplying the brass coupler with my kits.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top