Hey guys, as many of us have done in the past I am upgrading my Fett. I have gone with a Premium Animefan cold cast bucket and I am very pleased with my decision.
Since I have the new helmet I will be retiring my original lid to a display shelf as a personal accomplishment and display piece, in doing so though I am pulling out the servo and RF board that I had installed.
Now when I installed the servo in my pep helmet I was able to install it in such a way that the servo gear was almost flush with the outside of the helmet so attaching the RF stalk was relatively easy. The method I used previously will not work for my new helmet, and I need to find an aluminum shaft extension for the servo. I am using the HI Tec HS77B low profile servo and I can't seem to find the extension stalk for the servo anywhere. Could someone point me in the right direction.
Thanks
Since I have the new helmet I will be retiring my original lid to a display shelf as a personal accomplishment and display piece, in doing so though I am pulling out the servo and RF board that I had installed.
Now when I installed the servo in my pep helmet I was able to install it in such a way that the servo gear was almost flush with the outside of the helmet so attaching the RF stalk was relatively easy. The method I used previously will not work for my new helmet, and I need to find an aluminum shaft extension for the servo. I am using the HI Tec HS77B low profile servo and I can't seem to find the extension stalk for the servo anywhere. Could someone point me in the right direction.
Thanks
