propcollector
New Hunter
LinkSean has a new "D23" updated file on Etsy
3d printed Mandalorian helmet
- Thread starter stormtrooperguy
- Start date
MinuteFett
Active Hunter
3D printable helmet inspired by The Mandalorian
This listing is for a fully 3D printable file set to create a wearable replica of a helmet inspired by the recently released photo of The Mandalorian. Overall size measures approximately 10.5 (265mm) inches wide by 10.5 inches (265mm) deep by 11.4 (289mm) high. The attached archive contains the STL
www.etsy.com
looks like only the ears are updated. tHe overall shape is still a bit off.
Last edited:
rcthe1man
New Hunter
The stripe down the middle is updated too. The early one is flat with a trapezoid on the front.
I had already printed the first one before more accurate photos came out. Oh well, time to start again.
Stevie
Hunter
I felt bad for this forum section... It needed some posts
A while back I got the 3d model file from Sean Fields: 3D printable helmet inspired by The Mandalorian
It's super early. We haven't seen all the sides. But when printing a helmet costs $30 why not?
My usual formula is print, sand, coat with glazing putty, then sand forever..
View attachment 173836
Eventually getting to a nice smooth finish...
View attachment 173837
My first paint job wasn't great... the silver wasn't shiny and the weathering was overdone...
View attachment 173838
I sanded it smooth again and used rub and buff for the next pass...
View attachment 173839
Oh and Sean left the back pretty plain. I felt like that was sorta boring, so I modeled up a key slot and added it in:
View attachment 173840
Are you ever going to sell these or comission? Very interested
