mando commando paints

InfraFett

Active Hunter
Hey guys. I just went ahead and decided not to do Boba Fett. Instead, I'm doing a custom. My main paint colors will be Green and Black, and maybe grey. I looked in the Auto Section of Wal-mart today and they had paints that can be used on Fiberglass after it has dried. They had the right colors for what I was wanting to do. I PM'd a few you guys and I thank you for your advice. Anyway, would those paints do ok on a Rubies Helmet or is that not such a good idea?

Thanks guys.
 
Sent you a PM.:)
A couple coats of a good good primer should allow you to use automotive type paints. It's always a good idea to test it first on a scrap piece. Like say the vinyl piece that you will cut out in the front when you install a full t visor.
 
Thanks. I'm going to have to save it so I can read it on what to do next. Now all I gotta do is talk to a friend of mine about that visor.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top