Helmet, gauntlet & knee

kunak

kunak

New Hunter
Hello!


So I'm doing a scratch build of the armor, and I have a little problem on how to make the helmet, gauntlet, and knee.

So what will be the easiest way to make them?

What have you guys used in material and templates?

I do not have access to illustration boards.
 
What about plastic sheet? PVC 3mm thick "sintra" is what many people use for the armor, the helmet templates work best with thick paper stock or illustration board. Not sure if anyone's used sintra for the helmet.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

viewoptic
viewoptic's ESB Build
3 4 5
Replies
99
Views
7,563
viewoptic
viewoptic
Slave1Pirate117
Slave1Pirate's Aluminum ROTJ Boba Fett Build PIC HEAVY
11 12 13
Replies
242
Views
19,097
Slave1Pirate117
Slave1Pirate117
Ord Mantell
Ord Mantell's ESB build
25 26 27
Replies
533
Views
95,178
RamSkirata
RamSkirata
Back
Top