Droidbait's Jango Build

Be careful using a heat gun on fiberglass. I have had parts blister, maybe from trapped air bubbles? I have had better success dipping in boiling water. You can just heat the affected area this way without either heating the whole helmet or focusing too much heat in one area.
You're right! I totally forgot about boiling water. Duh! I couldn't remember if there was another method but that was it.
 
My DEC Westar aluminum kit came in today! I have two now!
20200729_150301.jpg
 
Wow! Are these available always? Or was it a run?

I think available till they run out? Not really sure but here is the link for them.

 
So, when you polished your armor pieces, did you follow Cruzer's instruction thread?
Yes, I look at his threads religiously. My problem was with the cold cast itself. Some of the areas dont have powder. I have a 2 items from Cruzer and they buffed amazing. Other sellers quality not so much. I also used MAAS metal polish. The armor looks so much better.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top