Droidbait's Jango Build

Took a few days off from working on the pack. Fixed the broken parts and attached them with epoxy. I will still need to sand them smooth. But this is where I am at with it. Oh yeah and sprayed filler primer to fill in all the scratches and stuff. It looks good like this haha.
20200624_172259.jpg
20200624_172313.jpg
20200624_172325.jpg
20200624_172342.jpg
20200624_172357.jpg
20200624_172421.jpg
 
Another bad luck moment. Not my fault. But I wrapped all my armor pieces in bubble wrap so they wouldn't get damaged. Well I opened my gauntlets so I could show my friend. And when opened it, the front of the gauntlet was cracked. There is no fiberglass mat on the corners, just gelcoat. So their isnt any structure support and is prone to cracking which this was the case. It must have cracked while I was moving. I epoxied the crack so it wouldn't crack more.... :( xD gorram! It's never ending...
20200628_124458.jpg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top