Bondo or Fiberglass?

SBobba

New Hunter
Hi guys,

I've started looking into making a helmet and decided to get my materials ahead of time but ran into a problem. I'm using AntMan's turtorial and WOF templates and he suggests using bondo car body filler to finish my helmet. But I remember other people using fiberglass resin to do the same thing. Which is better? Is there a special way to fiberglass a helmet? Is fiberglass hardier? Any help is appreciated.

Thanks,
Bobba
 
i used the fibreglass resin to stiffen the paper build, which made it easier to fibreglass the inside (rigidity), then bondo the outside. lots of info on youtube
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top