BKBT Jango Thighs

I have both left & right pieces rough trimmed & will probably get the final trim done tomorrow. Hopefully I'll be able to mold these on the weekend. The finished height will be about 11" which I concurred with Donny's measurments. If you are under 5' 7" you could trim the armor a bit if needed. If you are 6'+ the armor should still fit fine, just watch the spacing of your pieces & position them farther apart.
 
Here is a new round of pics. The armor has been further trimmed & I can see a couple of areas that I need to address still. The top needs to rounded a bit more as well as the side. Again, others eyes are welcome. Sometimes you can get to close to a project & be blinded to details that are obvious to others.

DSCN1653 copy.jpg


DSCN1654 copy.jpg


DSCN1655 copy.jpg


DSCN1656 copy.jpg
 
Just a quick update: The thighs are molded & the jacket mold will be finished tomorrow. First pics of the first pulls should be up on Sun. I have a few people to "take care of";) & then I'll do a small run of these to finance the materials for the shin armor.
 
Pics of the first test pull from the molds. These are now ready to go & I'll start casting up sets right away. There are a couple of people I need to take care of first & then I'll be posting a thread in the Cargo Hold.

TDH1 thigh.jpg


TDH2 thigh.jpg


TDH3 thigh.jpg
 

Similar threads

Loufett
Loulou fett Jango build
Replies
15
Views
2,349
Loufett
Loufett
DrToothache
DrToothache's Jango WIP (Kamino)
2 3 4
Replies
79
Views
13,765
DrToothache
DrToothache
Campii
WIP: Westar 34 Blaster
Replies
2
Views
2,261
Mandalorian Guard
Mandalorian Guard
Mythosaur
Flightsuit Sleeve Tutorial
Replies
0
Views
2,038
Mythosaur
Mythosaur
MachineCraft
Definitive Metal Ears for Lineage Helmets - MachineCraft Replicas
2 3
Replies
44
Views
14,135
MachineCraft
MachineCraft
Back
Top