Superjedi's Fugly ESB for Sean Y.

Did a bit of clean up work around the visor opening and the skirt. The owner sent the helmet with the majority of the prep done, and I just smoothed things out a little.
Here's the helmet under a couple of coats of Tamiya primer. This is the cleanest it'll look from here on out!

20230520_202712.jpg 20230520_202652.jpg
 
I'm waiting for the first color on the back panels to dry, so I scuff sanded the metal ear set, masked off the bare metal portions, and hit them with some self-etching primer.
I'll let this cure for at least 48 hours before hitting them with the color coats.

20230520_202633.jpg
 


Write your reply...
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top