Here, I have done a test spraying with my airbrush experimenting with the European DK green. When the US med green comes in tomorrow, I will post a comparison pic for ya.
Ok, got to painting today, pic 1 is inside with a light on and flash any daylight left.
Pic 2 is taken outside with hardly
Pic 3 is the comparison.
The dark green looks closer to that italian olive spray paint. The only other question is, should I seal this with anything for a protective layer? Or will it be fine?
Ok, this morning I check on the armor, and didn't realize it left such a rough coat on it, so I used a real fine sandpaper and cleaned it up, than added a new coat. Later in the afternoon I decided to do the details on it. The weatherin pics aren't shown, but I did that a little bit ago.
I picked up a bottle of the Polly US Med Green, and tested it vs. a lightened Euro Dark green. I didn't get it quite light enough, but no matter as it has way too much blue in it. I also tried out a lightened Topside green, which was closer, but also too blue. Seems too much trouble to keep mixing to match it. If I end up using Med Green, I'll just use the acrylic and keep my enamel air brushing on top.