Scoutleader
Active Hunter
Nice bucket and great job with the painting
I thought of something that would make your t-visor really stand out. Remember I said something about a pink t-visor? Well how about Pink window film for your BM Visor
here is the website and a pic! http://www.gilafilms.com/Automotive/AutoViewer.asp?CarChoice=whitecar&Step=ShowFilm&FilmChoice=XCPink
Ha. My bad, I should have gotten you to paint mine! VERY VERY nice! I absolutely ADORE it! <3
go to ace hardware and find one of the old guys that have been working there since the dawn of time and ask for chicago screws (they're two part screws, one part screw the other a shank the screw threads into). then stop off in plumbing and get some plumbers putty (i find mine at walmart). when you get home figure out where all the anchor points are going through the visor, i.e. drill some holes through the visor (make them a kinda long, so you have a little room for adjusting. then mark the spot on the inside of the helmet, put a small ball of the putty on each of the spots then set the shank into the putty.
disclaimer: i used just the putty to hold the visor into my sgt fang helmet, but i plan on using this described technique when i get around to doing my ms3. i have no idea how well it will work with the dp material. but i did use it to hold snaps to sintra tabs and it holds incredibly well to that. (then i gooped the snap-tab to the inside of the armor)
Here is a pic of Chicago screws so you know what they look like