My aluminum art piece

cyberpyrot

Active Hunter
Here is a little piece I’m working on I recorded a live video on face book of the process but I’m terrible at recording.

5151EBDC-C30F-469E-A4DB-FFD1EDE8ECEE.jpeg
 
Thanks! Any place where I can finde more details on this? You did a real good job, I think! What tools did you use? What kind of hammers? Anything for a vice?

I have some laser cut blanks coming I will produce a video soon it’s not that hard to do. I use simple tools and anvil from harbor freight.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top