MLC back panel attatchment.....


Active Hunter
I finished my harness and straps that go inside the jet pack today. I was wondering if anyone with one of bad boys would share how they installed this part. I know it needs to be sturdy.
Thanks everyone,
Thanks for the pics Seeker, I'll try the velcro tonight. I have the industrial kind. Think I'll run all the way across the top and do the corners on bottom.
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.