Helmet "Mole"?

If you are talking about the piece on the right cheek. (I have dial-up @ work and high rez images take weeks to load...) That is the DATA PORT...actual part: Borden Connector. If I am wrong, I will re-read and edit my post....I hate dial-up.
 
I don't have an actual borden connector, but I just checked mine off of my M_S1 and it in fact reads 9MM (11/32"...just under 3/8").

Hope it helps...
 
Well, as long as we're reviving the thread...here's mine installed in my BKBT Jango bucket that I'm converting to a Boba...;)

Cnv0026.jpg
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top