01Hawk
Active Hunter
Thank you everyone for the positive feedback and Raf for the constructive feedback as always .! the use of pictures makes it much easier to obtain that 100% accuracy level.
I have a 3D printed flashlight and a 6050 which is too big. I want to get a 6051 lamp before cutting a hole. Currently I mounted a light bulb off an energizer lamp. I blacked out the area that is to be cut out. The range finder is a bit of a mess. The upper ear is cocked, I used light gun metal gray for them because I liked the color. I will be going back to a natural metal color after this weekend. I didn't put much time into the rangefinder since I knew I would be ripping it apart for a JC 27 light kit. Tomorrow ( today actually) will hopefully it will addressed
I have a 3D printed flashlight and a 6050 which is too big. I want to get a 6051 lamp before cutting a hole. Currently I mounted a light bulb off an energizer lamp. I blacked out the area that is to be cut out. The range finder is a bit of a mess. The upper ear is cocked, I used light gun metal gray for them because I liked the color. I will be going back to a natural metal color after this weekend. I didn't put much time into the rangefinder since I knew I would be ripping it apart for a JC 27 light kit. Tomorrow ( today actually) will hopefully it will addressed