rangefinder

now i know your going to say"well why dont u look in a thread" but u see i have and i cant find one anyways i am trying to find a picure that i can use as reference as to naming parts of the helmet and i can find one anywhere because i need to make a rangefinder for my helmet because it broke off.....give me info............
 
Last edited by a moderator:
i was wondering if anyone had any methods of making a rangefinder and stalk for a DP because i just got mine yesterday and i found that it had broken off.ive checked with some people and they are charging me like 30-40 for a new one and i was wondering if it was possible to build my own so that i dont spend as much money because i am only 15 and have no money....if you could point me in the right direction that would be great....THANKU...
 
There are a number of people who have Stalks and Range Finders available. I just got a resin one for my DP 97, and need to clean it up a bit.

It came with the Bucket I bought, so I can't help you find one though.

The really sweet ones are the translucent ones.

badger
 
I have a resin RF and stalk you can have :D
Both need cleaned up a bit, but aren't too bad.
PM me with your Info on where to send it.
Thanks,
Robert E.
 
Last edited by a moderator:

reidemiller wrote:

I have a resin RF and stalk you can have :D
Both need cleaned up a bit, but aren't too bad.
PM me with your Info on where to send it.
Thanks,
Robert E.
sandlercd_22 so u still need my info ;)

.:: START EDIT ::.
Ok here's the blueprint of my plaster RF
just need to make a block with the same size or
a lil more bit, then u can use a dremel or a similar tool
and voila RF
<img src=http://200.72.163.179/cdref/tdh/Helmet/rf2.jpg>
.:: END EDIT ::.
 
Last edited by a moderator:
Well,
I can help out to! I think I have A D.P. antenna and rangefinder.I think it's broke.But not in A bad place.It could be glued,sanded,painted.It would be just fine.I also have A rubies Jango rangefinder,antenna.If this can help somebody out,Drop me A P.M.
Good Luck
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top