attaching the rangefinder glass

XWingAce77

New Hunter
Hey everyone! looking at the best option to attach the glass lens in the rangefinder that's non permanent so I could add electronics in the future, any suggestions? my mind went to 3m tape or another strong double sided tape.
 
My luck it would become unstuck…fall…and break…:lol:
I was thinking the same thing but Amazon can deliver. The magnets they sell have some serious pulling power. I kid you not, Sunday I was sorting my magnet pile, working on Stormy Armor, and two small ones jumped and smashed together on my finger.... and seriously made my pointer finger bleed. Lol. I was not happy about that one.
 
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top