Rangefinder stalk "taper" measurements?

DL44 Blaster

Well-Known Hunter
First,I'll just want confirmation that the ESB does indeed have a taper????

Second, if indeed ESB does have a taper, is there a difinitive measurement of the thickest part (when viewing from the side) at the base near the hinged earcap to the thinnest part up by the rangefinder itself??

I've got some final "tweaks" to do to my MSH/ESB and want this final part taken care of once and for all.

Thanks for any help offered,
I don't know the exact measurement of the taper, but I can at least confirm that the ESB and any other ILM Fett helmet has the taper.
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.