Question about size


New Hunter
Well, since i just reciently finished my helm, i put it on for the first time (not just to line things up, but to see how it looks compleated) and im kinda worried that i may (and this sounds weird lol) have to short a neck for this helmet...what do you think?


Granted, this pic is a lil off...there is actually about 2 to 2 and a 1/2 inches between the bottom of the bucket and my sholder


  • helmet-on.jpg
    31.9 KB · Views: 133
Dont worry about it. If you are going to put this on dispay somewhere thats fine. If you are going to bump around in it with your college friends like I do, thats fine too...:lol:

Anyway we're talking about your neck here. Its not like you can cange it.:)
Put some padding in the top or a hard hat liner.
Some more foam on the top of your head to make it higher, along with a neckpiece/baclava to cover up any skin showing should make it perfect.
the way you wear it makes all the difference.

a bit of foam in the top to raise it up is the biggest thing.

then the way you stand. i found that i naturally tend to want to look down when i'm wearing it, so as to avoid the blind spots from the cheeks of the helmet.

if i keep my back and neck straight, the helmet doesn't want to hit the chest as much.
go to a sports store and buy one of the helmets that have an inside head support liner. (or a hardware store for a hard hat liner)

rip it out and mount in your helmet, this will keep it off shoulders and keep it from rolling around like a bell.
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.