New Prototype BKBT Chest Armor

Not much in the way of updates. I have been busy with with work this last week & haven't made much progress. This project has now been bumped to the top of my list!
 
If you make a list, because there seems to be a lot of interest, I'd like to be somewhere near the top, twitchy finger on the "send money" button.:)
 
I have one big issue with your armor BKBT, its not in my hands!

Seriously, would be interested in getting one of those center baggette for my current armor. Don't wanna mess with cutting out the one that came with my current set.
 
I'm almost there! These are the first pulls from my molds. The center diamond is resin cast but the rest will be fiberglass. I still have to make the molds for the ab plate & shoulder bells & then I will be good to go!

TDH.jpg
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top