help to make the boot armor

Nanofett

New Hunter
Hi friends

Anyone have any idea how to do this.
I am complicated with curves and against curves to do it in sintra or similar
 

Attachments

  • CC-Boots-2.png
    CC-Boots-2.png
    147.8 KB · Views: 247
I made all of my armor masters from sintra, then molded and casted in fiberglass.

you could always sculpt in clay and vacu form over that if you were just doing a one off
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top