KidAkira's Finished ROTJ BM Armor

KidAkira

Active Hunter
Here's all the green parts of the armor. Everything here is BM's fiberglass armor. I can't say enough about the Quality of BM's Stuff. I think some of these shots give a good view of the curves of the pieces.
CA1ka.jpgCA2ka.jpg
CA3ka.jpgBA1ka.jpg
BA2ka.jpgKP1ka.jpg
KP2.jpg
Cheers KA
 
Question:

What color did you use for the scratch marks seen here?

armor.jpg


And I was wondering, has any one ever put out a tutorial with the steps for doing a ROTJ version of armor. I am at a point where I know what needs to be done now, just not sure in which order.
 
FTLOF, The colour i used for those scratch marks was Tamyia spray paint Olive Green (AS14). I used the layer technique so in order it would have been the silver (mask areas) Yellow (mask areas) Tamyia Olive green AS14 (this colour was only sprayed locally in the required areas - mask areas) Dark green, then weather. Hope that helps ya!

Daz, Thanks for the compliments! I'm glad I could do justice to your excellent armour. Again, a pleasure to paint!

Cheers
KidAkira
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top