Jennari's Jango Build

Agreed!! Great job getting the colour just right!
The fact that you're also showing off how it looks on camera in different lighting is what counts the most and it looks pretty identical in each pic. Solid work.
 
Fantastic job on the flightsuit, the color is perfect looking!!
Girth belt is great also, Great progress!! Ori'jate bora ner vod!
 
How exactly did you attach Seeker's jetpack harness to your jetpack?

Is it just with a screw in the jetpack and some holes in the webbed black straps?

It looks like it holds your jetpack pretty well.
 
When you have a moment could you snap some pictures of it? I saw them on the last page, but I didn't quite understand how it looked with the straps attached.

You could PM me as well if that is easier. Either way works for me!
 
Not much in the way of progress, and bad quality photos, I know, but I figure it's still worth showing. Finally finished the knees. Now I just need to know if these will pass muster, or if I should buy a set and use these for a different kit. If they're okay, then on to weathering.

XZ9oN9J.jpg


bm40zIE.jpg


sma7WmA.jpg


DDP6rpG.jpg


DMZAAbb.jpg


2BRIPru.jpg


p9T3S25.jpg


vfUodZp.jpg
 
Unfortunately, not much to show, but at least I've finally got the chest plates shaped. We decided not to do anything else to them now in case they need adjustments.

ZuumrDz.jpg


So, just to list what still needs to be done:

- Boot and chest plates need to be sanded, primed, and rub'n'buffed
- Waiting on my new helmet
- ALL the armor needs to be weathered and attached to the soft parts
- Flight suit needs a bit of color adjustment and button holes added to the legs
- Flak vest needs slits for jetpack straps to feed through, as well as fixed shoulder flaps
- Boots need snaps and weathering
- Knee armor needs the darts secured in place
- Gauntlets need to be hinged and have greeblies and weapons added
- Jetpack needs vent re-attached


All in all, I'm feeling a lot better about getting this done in time. Not as much left to do or worry about as I thought.
 
Minor progress.

Gauntlet hinges are secured on.

KtP8lO3l.jpg


tvwPXt5l.jpg


myz21BLl.jpg


xxaTRYql.jpg


oC4d0egl.jpg



And have the snaps on my boots and plates. (Yes, the plates might need to be secured more so none of the gray area shows)

LhzpcCXl.jpg


Q4q5pjzl.jpg


Ak0TciCl.jpg


1NmbEyCl.jpg


hfK9yHvl.jpg



Helmet's been sanded and primed.

Button holes have been added to the flight suit.

All that's left to do:

- (Possibly) re-shape the chest armor; then sanding, priming, and rub'n'buffing
- Weather everything
- Add greeblies and gauntlet extensions where needed
- Paint/Rub'n'buff the helmet
- Attach the armor to the soft parts
- Make a few minor repairs

Getting closer!!!
 
And now I've got all the leg plates strapped on. (Excuse the lack of my right shin plate; it needed some repairs) Might need some adjustment and more snaps to make sure they sit correctly, but otherwise good.

rtw9pcUl.jpg


K5078rjl.jpg


QmQvPCIl.jpg
 
Great looking work! One question, is the thigh armor undersized slightly? I'm just basing that on pictures I've seen online of Temura, but I haven't seen any without the holsters in place covering it up.

Again, great work!
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top