Jango Fett Belt/holster

The holster straps around the back of your thigh as well to hold the thigh armor in place. Some people also put 2 screws through the holster into the thigh armor.
 
I'm working on my Jango Holsters also but haven't been able to find the answers I'm seeking.
For the lower strap (around the leg) how far up from the bottom tip of the holster should the strap be located (center line of the strap)? (holster is for MR Westars)
How is the lower strap (around the leg) attached to the holster, Chicago screw, stitched, or glued?
Last question for the upper two straps on the holster do they both attach to one Chicago screw, two separate Chicago screws, or some other way?
Any help would be greatly appreciated.
Thanks
 
For about the cost of a good belt rig, I am selling all of my leather patterns and molds with samples and support. Build a couple of sets and recoup your cost.

See the Cargo Hold.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top