How to open up the RF

Weren't some of the RFs on the 95's solid resin? This may be the case. The others were injection molded (and hollow). There is a very clear seam that goes all the was around the top of the RF. This should pop open easily if it is a hollow one that you have.
When I tested the DP95 RF with my lights, the lid just snapped back tightly. I wouldn't do anything else since it stays in place perfectly fine.

Jedi-Bob wrote:

Once you get it open and install the do you reseal it so it is not permanently sealed???
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.