How to scale a helmet file to fit?

bobawife

New Hunter
I’m 3D printing everything for my husbands Boba Fett build, but I was super intimidated by the helmet after a few print fails so my brother was nice enough to buy an unfinished 3D printed one online as a birthday present. It won’t work, there’s way too much chin sticking out. (He’s 6’1). So now we’re re-attempting to print it ourselves again. How do I make the file I bought fit his head? Is there a certain way to measure his head? I’m sure there will be some adjustments needed to be made to the file to make it fit. We’ll also need to add room for padding somehow. Has anyone figured this out?
 
This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top