Active Hunter
All you need to do is heat it up to bend it. Just use a hairdryer, heatgun, or just boil up a pot of water and dip the pieces into it, but wait until it's pretty hot. Then bend away, and when you're done, put it under some cold water.


Sr Hunter
Or stick it in the oven with the door open on a low temp.
Sintra? Oven? I don't think so... if you leave it in the for right ammount of time you'd probably be fine, but it may destroy the foam and it may be difficult to pull out and form. Sintra cools off extremely quickly.

I recommend boiling water or a heat gun. But if you use a heatgun, use it like a blowdryer, don't leave the head aimed at a single point or it will destroy your armour.

This thread is more than 16 years old.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.