FIELDMARSHAL EE3 ALUMINUM CNC PROJECT

Notice the profile machining on the inner cuts,,, this stock bracket is not simply cut straight threw like a cookie cutter... the original buildes must have hand shaped these varing radius ............
IMG_3955_zpshdmgnqeg.jpg

IMG_3948_zpsdi29epkp.jpg
 
Awesome work so far! as usual though :)
the cast grips are absolutely awesome! I would absolutely not polish them though, I think they are great as a raw cast and a bit too idealized when polished.
 
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top