Fiberglassing the inside?


I have heard about reinforceing the inside of your helmet with fiberglass. Has anyone done this? anyone have a tutorial? How's it hold up?
Whoa! That'll work? That's awesome cuz I'll be able to get rid of the flimsiness of my '95 DP bucket...correct?

Is it expensive? And how much of it would I need to get a good thickness?


Mirax H wrote:

I used a fiberglass automotive repair kit to do the inside of my helmet. Just follow the directions on the box :)
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.