fan placement

Yroc Yar

Active Hunter
has anyone besides me ever noticed that the right ear parts look like they are 2 pieces that go together ? i figured that maybe the bottom piece would slide down to open a vent , so that's what i did to my new J D bucket . then i put a fan inside to suck air in , and i tell you it works great , i can actually feel a breeze going across my face .in this pic you can see the fan inside the helmet and the " vent" piece is al the way down .
well , thanks . what i did was , cut a groove behind the bottom part , then epoxy a bolt to the piece . then i just use a wing nut that has a washer on it to tighten and loosen it . pretty simple , huh?...more pics .

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.