Does Bondo stick to ABS?


Well-Known Hunter
I have a set of GA. Some of the pieces are Boba style (dents, etc.). What is the best wat to fix these areas? I have Bondo but am hesitant to use it. Thanks.
Yes it will adhere to just about anything provided the surface is prepped properly.Just sand it thoroghly with some 150-220 grit sandpaper,and wipe clean with some rubbing alcohol,and the bondo will stick fine :)

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.