Jet Pack Added smoking thrusters and lights

howlingwind13

New Hunter
Wanted to do the smoke and lights for the thrusters. Was a bit of an issue because the neck thrusters that join the jetpack were solid. And the pack was technically paint finished. So I carefully cut the neck off, hollowed out the thrusters to accommodate a pvc pipe that would run through the pack, join the thrusters and act as a channel for the lighting and smoke tubes.
Even though no one will ever really see the rig I decided to distress it add some greeblies just for fun.
Mike
 

Attachments

  • 20221116_215504.mp4
    11.7 MB
  • 20221116_215504.mp4
    11.7 MB
  • 20220914_191414.jpg
    20220914_191414.jpg
    1.3 MB · Views: 143
  • 20220914_202401.jpg
    20220914_202401.jpg
    1.1 MB · Views: 138
  • 20220923_185311.jpg
    20220923_185311.jpg
    2.3 MB · Views: 133
  • 20220923_191938.jpg
    20220923_191938.jpg
    1.4 MB · Views: 137
  • 20220923_202504.jpg
    20220923_202504.jpg
    1.8 MB · Views: 144
  • 20220926_194636.jpg
    20220926_194636.jpg
    1.4 MB · Views: 147
  • 20221116_215517.mp4
    10.8 MB
Unfortunately no, I bought a jetpack, thruster kit from etsy. It came with the fans, lights and vape pens...
the the thrusters had cups, but I had to so heavily modify the kit, it was barely recognizable.
The project box was something I decided to put it all in just to stabilize it
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top