501st approval suggestions

spicy fett

Active Hunter
Hey guys I finished my build a while back and I have been nervous to say the least to submit my request to join the 501st due to being rejected after all that hard work I poured into making this suit. So I wanted to post some pictures and get some feedback from y’all to see if there are any major or minor things I should change before submitting my request! I couldn’t have gone this far without y’all’s help and knowledge and I just need a little more help guys!
 

Attachments

  • E8991DFD-D548-4551-AF02-7CB8BB18AAA5.jpeg
    E8991DFD-D548-4551-AF02-7CB8BB18AAA5.jpeg
    3.9 MB · Views: 267
  • 9ED2DE32-34D9-4E6E-8D17-1C7A8EFFEA55.jpeg
    9ED2DE32-34D9-4E6E-8D17-1C7A8EFFEA55.jpeg
    4.2 MB · Views: 254
  • EF740748-5F17-4C5B-A56F-BA42F1C05D6C.jpeg
    EF740748-5F17-4C5B-A56F-BA42F1C05D6C.jpeg
    4.1 MB · Views: 233
  • DDD855C4-89DD-4D8C-8BF4-89A2E46694F5.jpeg
    DDD855C4-89DD-4D8C-8BF4-89A2E46694F5.jpeg
    4 MB · Views: 234
  • 3A30E83C-ECCB-40EB-A2A1-E7959E50534F.jpeg
    3A30E83C-ECCB-40EB-A2A1-E7959E50534F.jpeg
    4 MB · Views: 215
  • 1E94ED56-1C9A-4AF0-AF13-ACB7F47229B2.jpeg
    1E94ED56-1C9A-4AF0-AF13-ACB7F47229B2.jpeg
    4 MB · Views: 208
  • EFAD6A58-015A-410C-82A2-3CE304476ABC.jpeg
    EFAD6A58-015A-410C-82A2-3CE304476ABC.jpeg
    4.1 MB · Views: 216
  • E66478F6-7173-48CC-9C93-702404B70FE9.jpeg
    E66478F6-7173-48CC-9C93-702404B70FE9.jpeg
    4.1 MB · Views: 266
Overall you look good! A few things:

  • The cape is a bit too long, I think. It should end at the knee.
  • Girth belt needs to be tightened in the back.
  • The sidearm should be attached to the scuba harness waist strap.
  • The knee and thong straps could use some more weathering, imho.
  • They might ask for more weathering on the flight suit.
  • Double check the arrangement of your braids against the CRL.
  • They may ask you to reduce the amount of flak vest showing beneath the ab plate.
That’s what I see for now, but you will be asked to provide detailed helmet photos, and there could be issues there. Same goes for the gauntlets and jetpack. Ultimately it will come down to your GML and, if needed, the BHG.

When folks say that Fett is the top of the mountain in the 501st they are not kidding. Most Fetts are not approved on the first try.

Best of luck! I’m working through feedback and revisions myself so I’m right there with you.
 
Hey thanks guys I really appreciate the feedback! I got the helmet covered and broke down and got someone to do a professional paint up because I know the one I did myself wasn’t going to cut it! I did already trim down the armor and I’m actually working on painting up some new chest armor that’s a tad bit larger than the ones I already have! So maybe I will wait until I get my new helmet and replace the cape before I try submitting. For now I just wanna go with basic approval because honestly my bank account can’t take infamous right now
 
Shorten the boba thong, needs to be tight, glad you went with a pro helmet paintup, that's like the most important costume piece...return edges for plates needs to be trimmed by a lot, glad you are on that too....you are on your way, just tweaks, it's a long road for that 501 approval
 
BHG is a very interesting sub set of Star Wars costuming groups. Just looked through the rules and regs.
They have a "nefarious" character requirement. :D
 
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top