Weathering the ammo belt - QUESTION

Depends on what it's made from. You can add a little wear and tear with scratching and sanding, but be careful if it's vinyl that you don't go too deep. Add some grime in the crevices and edges and you'll be set.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top